Hi Everyone,
As you know we have gone through a lot of material from the start of this workshop series, so tomorrow I will be in the Makerspace in Singer Hall, room 126 from 3:30-5:00 pm to help you through any points where you may be stuck. We can troubleshoot anything you are struggling with in Fusion 360, review laser cutting or set up a laser cutting job, or I can show you how to use the sewing machine. It is designed to be an open session to help you.
Please be aware that the Makerspace will be closing this Friday at 5:00pm through the Fall Break to allow for the move back to Whittier Hall. Our goal is to reopen in our renovated Whittier Hall location after Fall Break. Once we reopen, I am planning to have an in-person session with you on 3D scanning. Please stay tuned for announcements.
Hope to see you if you can make it tomorrow!
Sincerely,
Jacquie